Programmer 48 x 96 mm
Programmable controller 15 cycles / 45 steps
Programmer 48x96mm (1/8 DIN), single control loop. Allows the programming of 15 cycles/programs that can provide up to 45 steps/segments, all of which can be configured by the user as raise/maintain/lower. Programming mode of the work cycle that is intuitive and simple to use even for inexpert operators. Step end wait software functions (in case of a delay of the process on the programmed setpoint value) and Cycle Recovery mode (after a power cut-off) are the main features of this programmer that has been specifically designed for the automation of industrial kilns, climatic chambers, dryers and the management of ther
Box | 48x96 (front panel) x 123 mm |
Power supply | 24...230Vac/dc ±15% 50/60 Hz (selection 24 - 110...230Vac with jumper) |
Consumption | 5,5 VA, 4W |
Display | 4 digits 0,4" green + 4 digits 0,3" red |
Operating conditions | Temperature 0-45 °C, humidity 35...95% RH (non condensing) |
Material | Box: Noryl UL94V1 self-extinguishing; Front panel: Silicon rubber V0 |
Weight | Approx. 350 g |
Sealing | IP65 (Front panel), IP20 (Box and Terminal blocks) |
Quick set-up options | Memory Card with / without battery, software LABSOFTVIEW |
Besoin d’un renseignement ? Nous vous répondons dans les meilleurs délais.
DYNATIME SA
Av. des Champs-Montants 16c
CH – 2074 Marin
Tél: +41 (0) 32 968 15 36
> Nous contacter par e-mail